Ip Prefix Lists; Implementation Information - Dell Force10 Z9000 Configuration Manual

implementing control-plane ACLs for CPU-generated and CPU-forwarded traffic. Using permit rules with the count option, you can
track on a per-flow basis whether CPU-generated and CPU-forwarded packets were transmitted successfully.
1. Apply Egress ACLs to IPv4 system traffic.
CONFIGURATION mode
ip control-plane [egress filter]
2. Apply Egress ACLs to IPv6 system traffic.
CONFIGURATION mode
ipv6 control-plane [egress filter]
3. Create a Layer 3 ACL using permit rules with the count option to describe the desired CPU traffic.
CONFIG-NACL mode
permit ip {source mask | any | host ip-address} {destination mask | any | host ip-
address} count
FTOS Behavior: Virtual router redundancy protocol (VRRP) hellos and internet group management protocol (IGMP) packets are not
affected when you enable egress ACL filtering for CPU traffic. Packets sent by the CPU with the source address as the VRRP virtual
IP address have the interface MAC address instead of VRRP virtual MAC address.

IP Prefix Lists

IP prefix lists control routing policy. An IP prefix list is a series of sequential filters that contain a matching criterion (examine IP route
prefix) and an action (permit or deny) to process routes. The filters are processed in sequence so that if a route prefix does not
match the criterion in the first filter, the second filter (if configured) is applied. When the route prefix matches a filter, Dell
Networking OS drops or forwards the packet based on the filter's designated action. If the route prefix does not match any of the
filters in the prefix list, the route is dropped (that is, implicit deny).
A route prefix is an IP address pattern that matches on bits within the IP address. The format of a route prefix is A.B.C.D/X where
A.B.C.D is a dotted-decimal address and /X is the number of bits that should be matched of the dotted decimal address. For
example, in 112.24.0.0/16, the first 16 bits of the address 112.24.0.0 match all addresses between 112.24.0.0 to 112.24.255.255.
The following examples show permit or deny filters for specific routes using the le and ge parameters, where x.x.x.x/x represents a
route prefix:
• To deny only /8 prefixes, enter deny x.x.x.x/x ge 8 le 8.
• To permit routes with the mask greater than /8 but less than /12, enter permit x.x.x.x/x ge 8.
• To deny routes with a mask less than /24, enter deny x.x.x.x/x le 24.
• To permit routes with a mask greater than /20, enter permit x.x.x.x/x ge 20.
The following rules apply to prefix lists:
• A prefix list without any permit or deny filters allows all routes.
• An "implicit deny" is assumed (that is, the route is dropped) for all route prefixes that do not match a permit or deny filter in a
configured prefix list.
• After a route matches a filter, the filter's action is applied. No additional filters are applied to the route.

Implementation Information

In Dell Networking OS, prefix lists are used in processing routes for routing protocols (for example, router information protocol [RIP],
open shortest path first [OSPF], and border gateway protocol [BGP]).
NOTE: It is important to know which protocol your system supports prior to implementing prefix-lists.
Access Control Lists (ACLs)
97