Ip Tftp Source-Interface - Dell Z9500 Command Reference Manual

Hide thumbs Also See for Z9500:

Table of Contents

ip tftp source-interface

Assign an interface's IP address in outgoing packets for TFTP traffic.

ip tftp source-interface interface

To return to the default setting, use the no ip tftp source-interface

interface command.

The IP address on the system that is closest to the Telnet address is used in the

outgoing packets.

Control and Monitoring

Introduced on the S4810.

Added support for 4-port 40G line cards on ExaScale.

Increased number of VLANs on ExaScale to 4094 (was

Introduced on the E-Series ExaScale.

Introduced on the S-Series.

Introduced on the C-Series.

Original command

— telnets to another device.

Enter the following keywords and slot/port or number

information:

For Loopback interfaces, enter the keyword loopback

then a number from zero (0) to 16383.

For a Port Channel, enter the keyword port-channel

then a number. For the C-Series and S-Series, the range

is 1 to 128.

For a 10-Gigabit Ethernet interface, enter the keyword

TenGigabitEthernet then the slot/port information.

For a 40-Gigabit Ethernet interface, enter the keyword

fortyGigE then the slot/port information.

For VLAN interface, enter the keyword vlan then a

number from 1 to 4094.