Ip Tftp Source-Interface - Dell Force10 S4810P Reference Manual

Defaults The IP address on the system that is closest to the Telnet address is used in the outgoing
packets.
Command Modes CONFIGURATION
Command History
Version 8.3.11.1
Version 8.5.1.0
Version 8.2.1.0
Version 8.1.1.0
Version 7.6.1.0
Version 7.5.1.0
E-Series
Related telnet
Commands

ip tftp source-interface

Assign an interface's IP address in outgoing packets for TFTP traffic.
C-Series, E-Series, S-Series, Z-Series
Syntax ip tftp source-interface interface
To return to the default setting, use the no ip tftp source-interface interface
command.
•
•
•
•
•
•
•
Introduced on the Z9000.
Added support for 4-port 40G line cards on ExaScale.
Increased number of VLANs on ExaScale to 4094 (was 2094).
Introduced on the E-Series ExaScale.
Introduced on the S-Series.
Introduced on the C-Series.
Original command
– telnets to another device.
For a 1-Gigabit Ethernet interface, enter the keyword
GigabitEthernet followed by the slot/port information.
For Loopback interfaces, enter the keyword loopback
followed by a number from zero (0) to 16383.
For the SONET interfaces, enter the keyword sonet
followed by slot/port information.
For a Port Channel, enter the keyword port-channel
followed by a number. For the C-Series and S-Series, 1 to 128.
For the E-Series, 1 to 32 for EtherScale, 1 to 255 for TeraScale,
and 1 to 512 for ExaScale.
For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet followed by the slot/port
information.
For a 40-Gigabit Ethernet interface, enter the keyword
fortyGigE followed by the slot/port information.
For VLAN interface, enter the keyword vlan followed by a
number from 1 to 4094.
127