Configuring A Grx1200 Pro/Grx1200 Gg Pro For Connecting A Ntrip Server - Leica GPS1200 Series Technical Reference Manual

34.3
Description
Configure a GRX1200
Pro/GRX1200 GG Pro
step-by-step
NTRIP via Internet
Configuring a GRX1200 Pro/GRX1200 GG Pro for Connecting a
NTRIP Server
A NTRIP Server is built into the GRX1200 Pro/GRX1200 GG Pro. It is part of the instrument
firmware.
Using port NET, a GRX1200 Pro/GRX1200 GG Pro can be set up as a real-time reference
connected to the Internet. Real-time data can be sent to the NTRIP Caster.
LEICA GPS Spider is needed to start the GRX1200 Pro/GRX1200 GG Pro and connect it to
the NTRIP Caster since a GRX1200 Pro/GRX1200 GG Pro cannot be started using the
RX1200. Once the sensor is started, LEICA GPS Spider can be disconnected and is no
longer needed. All functionality needed from LEICA GPS Spider to start the GRX1200 Pro/
GRX1200 GG Pro does not require a dongle and can be downloaded from the Leica website
download area.
The following table explains the most common settings. Refer to the stated chapter for more
information on screens.
Step Description
The following steps describe the configuration for connecting from
LEICA GPS Spider.
1. Configure the NET parameters.
2. Select Main Menu: Config...\Interfaces....
3. Highlight Remote.
4. EDIT (F3) to access CONFIGURE Remote.
5. CONFIGURE Remote
GPS1200
Refer to
chapter
20.5
761