Leica GPS1200 Series Technical Reference Manual page 1165

Survey - General
Step Description
4. CONT (F1) to access SURVEY Survey: Job Name.
Using the coordinates from the last used reference station
Step Description
The receiver must have previously been used as reference station.
After turning off, the reference station coordinates are stored in the
System RAM. They can be used again the next time the receiver is
used as a reference station. This means that even if the Compact-
Flash card that previously contained the reference station coordi-
nates is formatted, the last used coordinates can still be used.
1. Refer to paragraph "Access step-by-step" to access SURVEY Set Up
Reference Station.
2. LAST (F3)
The point ID and coordinates of the last used reference station are
displayed in grid. When no local coordinate system is active,
WGS 1984 coordinates are displayed.
3. Check the antenna height.
GPS1200
Refer to
chapter
SURVEY
Survey: Job
Name.
Refer to
chapter
1165