Configuring Guidance Options - Leica iNEX User Manual

4.4

Configuring Guidance Options

4.4.1 Defining A Guide Overlap
Normally the guidelines will be created at even swath widths apart at the
distance specified by the operator. In some situations it may be desirable
to intentionally over lap the treatment to ensure there are no misses in
the field. Defining a Guide Overlap will allow the system to automatically
reduce the spacing of the guideline by the amount entered without
affecting the treatment width.
1. From the Main menu press SETUP.
2. Press MORE.
3. Press
GUIDE
4. Press the Guide Overlap value
button.
5. Enter the desired amount and press
TICK.
4.4.2 Defining A Guide Offset
A Guide Offset is typically used in inter-row and tramline cropping
situations where it is desirable to use a previously saved Parallel or A+
Heading line but a small offset left or right of the line is required.
Defining a guide offset adjusts all Parallel and A+ Heading lines by the
amount entered until reset to zero by the operator.
1. From the Main menu press SETUP.
2. Press MORE.
3. Press
GUIDE
4. Press the Guide Offset value
button.
5. Enter the desired amount and press
TICK.
iNEX User Manual
OPTIONS.
OPTIONS.
Page 39 Rev 2