Survey - General
Set the reference
station coordinates
step-by-step
IF the coordinates of the
reference station
are those of the current
navigation position
Using a known point stored in the active job
The following table explains the most common settings. Refer to the stated chapter for more
information on screens.
Step
Description
1.
Refer to paragraph "Access step-by-step" to access SURVEY Set Up
Reference Station.
2.
SURVEY Set Up Reference Station
Select the point to be used as reference station.
A point may already be stored in the active job either by
manual entry, by measuring or by transfer from LGO.
If a new point is to be created, open the choicelist for <Point
ID:> and NEW (F2).
If an existing point is to be edited, open the choicelist for
<Point ID:> and EDIT (F3).
3.
Check the antenna height.
GPS1200
THEN
Refer to paragraph "Set the reference station coordinates
step-by-step", "Using the coordinates of the current navigation
position".
1164
Refer to
chapter