Leica GPS1200 Series Technical Reference Manual page 1141

Stakeout
Step Description
DTM Stakeout must be activated via a licence key.
The DTM job to be used must be stored in the \DBX directory on the
active memory device.
1. Start the Stakeout application program.
2. STAKEOUT Stakeout Begin
CONF (F2) to access STAKEOUT Configuration.
3. PAGE (F6) until the Heights page is active.
4. STAKEOUT Configuration, Heights page
<Use DTM: DTM only>
<Use DTM: DTM & Stake Job> is not covered in this step-by-step
instruction. The stake out procedure is identical as for the polar or
orthogonal mode but the heights to be staked are taken from the
selected <DTM Job:> defined in STAKEOUT Stakeout Begin.
This step-by-step instruction uses typical settings in all other fields on
all pages in STAKEOUT Configuration.
The selection for <Stake Mode:> is irrelevant since no positions are
staked.
5. CONT (F1)
6. STAKEOUT Stakeout Begin
<DTM Job:> Select a DTM job.
Check the other settings.
GPS1200
Refer to
chapter
30
43.2
43.3
43.3
43.3
43.2
1141