Leica GPS1200 Series Technical Reference Manual page 370

Config...\Survey Settings...
Field procedure step-
by-step
Step Description
4. CONT (F1) returns to CONFIGURE ID Templates.
5. CONFIGURE ID Templates
<Survey Pts: Bolt 001>
6. CONT (F1) returns to the screen from where CONFIGURE ID Templates was
accessed.
Step Description
1. Refer to "44.3 Surveying Points" to access SURVEY Survey: Job Name.
2. SURVEY Survey: Job Name
<Point ID: Bolt 001> is shown automatically.
At the point to be measured, place and level the pole on the point.
3. OCUPY (F1)
4. STOP (F1)
5. STORE (F1)
<Point ID: Bolt 002> is shown automatically.
6. Repeat steps 2. to 4. until all points with the ID Bolt XXX are surveyed.
7. SURVEY Survey: Job Name
The next point ID's are RoadXXXX, starting with Road0723.
Type Road0723. <Point ID: Road0723>.
8. OCUPY (F1)
GPS1200 370