Leica GPS1200 Series Technical Reference Manual page 545

CONFIGURE
PPS Output
Config...\Interfaces... - General
Description of fields
Field Option
<Output PPS:> Yes or No
<PPS Rate:> From 0.05s to
20.0s
<Polarity:> Negative Edge or
Positive Edge
<Limit Error:>
CONT (F1)
To accept changes and return to the screen
from where this screen was accessed.
NPORT (F4)
Available unless <Notify Msg: None>. To
configure the port and the device through
which the notification message shall be trans-
mitted. Refer to "22.16 Remote".
Description
Activates the output of PPS.
The rate at which pulses will be output.
Measure the time from the negative edge or the posi-
tive edge of the pulse.
The output of PPS can be restricted by the accuracy
of time. If the time accuracy is degraded below a
defined value, for example, due to a lack of satellites,
no PPS output is generated.
GPS1200 545