Leica GPS1200 Series Technical Reference Manual page 1224

Survey - Hidden Points
Step Description
A hidden point measurement device can be attached to the receiver
such that the measurements are automatically transferred to the
receiver.
1. Refer to "46.2 Accessing Hidden Point Measurement" to access
HIDDEN PT Hidden Point Measurement.
SHIFT CONF (F2) to configure hidden point measurements.
2. HIDDEN PT Hidden Point Measurement
<Method: Brng & Distance>
<Point:> The point ID of the current position. This is the known point
for the calculation of the hidden point.
Select a point stored in the job.
SURVY (F5) when <Point:> is highlighted. To manually occupy the
known point for the calculation of the hidden point.
To manually type in coordinates for the known point open the
choicelist when <Point:> is highlighted. Press NEW (F2) to create a
new point.
3. HIDDEN PT Hidden Point Measurement
<Azimuth:> The azimuth from <Point:> to the hidden point.
Type in an azimuth. When a hidden point measurement device is
attached to the receiver to measure the azimuth, the value is auto-
matically transferred.
GPS1200 1224
Refer to
chapter
23.1.7
23.1.7
44.3
9.3.2