Leica GPS1200 Series Technical Reference Manual page 512

Config...\Interfaces... - General
Field procedure
Step Description
<Message ID: GS2>
<Use Prefix: None>
<Send Reply: No>
6. Repeat step 5. accordingly for <Annotation: Annotation 3> and <Annotation:
Annotation 4>.
7. CONT (F1) closes the screen and returns to CONFIGURE ASCII Input.
8. CONT (F1) returns to the screen from where CONFIGURE ASCII Input was
accessed.
The coordinates of the points can be measured. Before storing each point, the gas analyser
is activated to take a gas reading at the point. The point can then be stored and the four gas
readings are stored as individual annotations along with each point.
Refer to "44 Survey - General" for information on how to run a survey.
GPS1200 512