Config...\Interfaces... - General
22.4.4
Configuration of
command step-by-step
Configuration of a Command to the Device
Step
Description
1.
Refer to "22.4.1 Overview" to access CONFIGURE ASCII Input.
2.
SHIFT CMND (F5)
3.
CONFIGURE Send Command to Device
<Command:> A message to be sent to the device through the configured port
when the survey or stakeout application program is accessed. This, for example,
allows the device to be started remotely. The last used command that was entered
is remembered as part of the active configuration set.
Type in the command to be sent.
4.
SEND (F3) sends the command to the device.
5.
CONT (F1) returns to CONFIGURE ASCII Input.
GPS1200
506