Reference Line
Field procedure step-
by-step
The following table explains the most common settings. Refer to the stated chapter for more
information on screens.
Step
Description
1.
Refer to "41.2 Accessing Reference Line" to access REFLINE Refer-
ence Line/Arc Begin.
2.
REFLINE Reference Line/Arc Begin
Select a job and a configuration set with the settings mentioned
above.
3.
CONT (F1)
4.
REFLINE Choose Task & Reference Line, Reference page
<Task: Measure to Line>
<Ref to Use: Manually Enter>
<Method: 2 Points>
5.
Highlight <Start Point:>.
6.
SURVY (F5) to manually occupy P1.
7.
Highlight <End Point:>.
8.
SURVY (F5) to manually occupy P2.
The Map page provides an interactive display of the defined refer-
ence line.
9.
CONT (F1)
10.
Walk to the first point to be measured.
GPS1200
1056
Refer to
chapter
41.2
41.4.2
32