44.6.2
Requirements
Access step-by-step
Survey - General
Accessing Initialisation for Real-Time Rover Operations
•
The active configuration set is a real-time rover configuration.
•
The configured real-time data format in CONFIGURE Real-Time Mode is other than <R-
Time Data: RTCM 1,2 v2> and <R-Time Data: RTCM 9,2 v2>.
The table describes the main access to SURVEY Survey: Job Name.
Access is possible from other screens where individual point measurements are needed, for
example from COGO Inverse with SURVY (F5).
Step
Description
1.
Refer to "44.1 Accessing Survey" to access SURVEY Survey Begin.
2.
In SURVEY Survey Begin select a job.
3.
Select a configuration set with the configured real-time data format
other than <R-Time Data: RTCM 1,2 v2> and <R-Time Data: RTCM
9,2 v2>.
4.
Select an antenna.
5.
CONT (F1) to access SURVEY Survey: Job Name.
6.
SHIFT INIT (F4) to access SURVEY Initialisation.
7.
Highlight the required initialisation method.
For Initialise while Static and Initialise on Known Point, the
antenna setup must be static on a pillar, a tripod or on a pole with a
quickstand.
GPS1200
Refer to
chapter
1183