Configuring A Real-Time Rover For Using Ntrip Service; Configuring An Access To The Internet - Leica GPS1200 Series Technical Reference Manual

NTRIP via Internet
34.2
34.2.1
Requirements
Configure access to
Internet step-by-step

Configuring a Real-Time Rover for Using NTRIP Service

Configuring an Access to the Internet

• Firmware v1.5 or higher must be loaded on the GPS1200 receiver.
• Firmware v1.42 or higher must be loaded on the RX1200.
To access to the Internet with a GPS1200 receiver, General Packed Radio System devices
will normally be used. GPRS is a telecommunication standard for transmitting data packages
using the Internet Protocol (IP).
A GPRS device can be connected in a clip-on-housing or with RX1250 via Bluetooth.
The following table explains the most common settings. Refer to the stated chapter for more
information on screens.
Step Description
1. Refer to "22.2 Accessing Configuration Interfaces" to access
CONFIGURE Interfaces.
2. In CONFIGURE Interfaces highlight Internet.
3. EDIT (F3) to access CONFIGURE Internet Interface.
4. CONFIGURE Internet Interface
<Internet: Yes:>
<IP Address: Dynamic>
GPS1200 752
Refer to
chapter
22.11