Configuring Determine Coordinate System; Configuring Determine Coordinate System - Normal - Leica GPS1200 Series Technical Reference Manual

38.3
38.3.1
Description
Access step-by-step
DET C SYS
Configuration,
Method page
Determine Coordinate System - General

Configuring Determine Coordinate System

Configuring Determine Coordinate System - Normal

The configuration of DET C SYS, normal method, allows options to be set which are used as
the default options within the Determine Coordinate System application program when using
the normal method. These settings are stored within the active configuration set.
Step Description
1. Refer to "38.2 Accessing Determine Coordinate System" to access DET C SYS
Determine Coord System Begin.
2. CONF (F2) to access DET C SYS Configuration, Method page.
3. Select <Default Method: Normal>.
This screen consists of the Method page, the Residuals page and the Classic 3D page.
The explanations for the softkeys given below are valid for all pages, unless otherwise
stated.
GPS1200 933