Reference Line
Step
Description
17.
When <Auto STOP: No> in CONFIGURE Point Occupation
Settings, STOP (F1) when enough data is collected. At least one
epoch of data must be recorded.
18.
When <Auto STORE: No> in CONFIGURE Point Occupation
Settings, STORE (F1) to store the point information.
The results are displayed on the screen.
It may happen that a point with the same point ID exists in the job. If
the codes and/or attribute values of the new and the existing point do
not match, a screen opens where they can be corrected.
19.
PAGE (F6) to access the Map page which provides an interactive
display of the defined reference line and the grid points staked rela-
tive to it. Displayed is also
•
the horizontal distance from the current position to the point to be
staked.
•
the height difference from the height of the current position to the
height of the point to be staked.
20.
Repeat steps 14. to 18. including the advice until all grid points have
been staked.
21.
SHIFT QUIT (F6) returns to GPS1200 Main Menu.
22.
The results are written to the logfile.
GPS1200
1086
Refer to
chapter
19.6.1
19.6.1
32