Removing And Installing The Two-Mass Flywheel - Skoda Octavia II 2004 Workshop Manual

– Tighten the hexagon nut of the assembly tool using a torque
wrench with adapter.
Tightening torque: 40 Nm.
– Check the fitting position of the rotor on the crankshaft again
⇒ page 57 .
If the dimension -a- is too small again:
– Tighten the hexagon nut of the assembly device to 45 Nm.
– Check the fitting position of the rotor on the crankshaft again
⇒ page 57 .
2.4 Removing and installing the two-mass
flywheel
Special tools and workshop equipment required
♦ Counterholder - MP1-223 (3067)-
or
♦ Engine mount - MP 1-202 (VW 540)-
♦ Bushing - T30010 (VW 540/1B)-
♦ Flywheel lock - MP 1-504-
Removing
• Gearbox removed.
Engine installed
– Insert the counterholder - MP1-223 (3067)- into the bore hole
on the cylinder block.
• Fitting position of the tool:
A - for tightening
B - for slackening
Engine removed
– Position the flywheel lock - MP 1-504- on the starter ring gear
and turn crankshaft until it rests against the sleeve - T30010- .
Octavia II 2004 ➤ , Octavia II 2010 ➤
2.0/100; 103 kW TDI PD Engine - Edition 01.2018
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not permitted
unless authorised by ŠKODA AUTO A. S. ŠKODA AUTO A. S. does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by ŠKODA AUTO A. S.�
2. Removing and installing sealing flange and flywheel
59