Removing And Installing Cylinder Head For Engines With Code Bmm - Skoda Octavia II 2004 Workshop Manual

– ... and at rear a small amount (∅ approx. 5 mm) of sealant - D
454 300 A2- -arrows-.
Note
Replace the gasket and the screws for the cylinder head cover in
case of damage.
– Tighten the screws for the cylinder head cover in the sequence
-1...13- to 10 Nm.
1.7 Removing and installing cylinder head
for engines with code BMM
Special tools and workshop equipment required
♦ Supporting device - T30099-
♦ Surface - T30099/1-
♦ Hook - MP 9-200/10 (10-222A/10)-
♦ Mounting bracket - T10014-
♦ Catch pan , e.g. -VAS 6208 -
♦ Pliers for spring-type clips
♦ Counterholder - T10051 -
♦ Locking pin - 3359- or -MP 1-301 -
♦ Crankshaft arrester - T10050- or crankshaft arrester - T10100-
♦ Workshop crane , e.g. -VAS 6100-
♦ Lifting device - MP 9-201-
♦ Sealant remover gasket stripper (bearing code GST, bearing
article no. R 34402), manufacturer Retech s.r.o.
♦ Protective goggles and gloves
1.7.1 Removing
– Switch off ignition and pull out ignition key.
– Drain coolant ⇒ page 143
– Extract fuel from the fuel tank
– Remove air filter ⇒ page 220
– Remove intake hose with connection piece
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not permitted
unless authorised by ŠKODA AUTO A. S. ŠKODA AUTO A. S. does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by ŠKODA AUTO A. S.�
.
⇒ page 172 .
.
Octavia II 2004 ➤ , Octavia II 2010 ➤
2.0/100; 103 kW TDI PD Engine - Edition 01.2018
⇒ page 193 .
1. Removing and installing cylinder head
85