Removing And Installing Charge Air Cooling Parts For Engines With Code Bkd, Azv - Skoda Octavia II 2004 Workshop Manual

– Remove the connection pipe for exhaust gas recirculation
-arrows- and heat shield for exhaust manifold.
– Unscrew nuts -arrows- and remove exhaust manifold with ex‐
haust turbocharger downwards.
Installing
Installation occurs in reverse order to removal. Pay attention to
the following:
Note
Replace the gaskets, the sealing rings and the self-locking
♦
nuts.
Fill exhaust turbocharger with engine oil through the connec‐
♦
tion fitting of the oil feed line.
Hose connections and hoses for the charge air system must
♦
be free of oil and grease before being installed.
Secure all hose connections with corresponding hose clips.
♦
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not permitted
unless authorised by ŠKODA AUTO A. S. ŠKODA AUTO A. S. does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by ŠKODA AUTO A. S.�
– Install pre-exhaust pipe
– Align exhaust system free of stress
– Observe the assembly instruction for hose connections with
push-fit couplings ⇒ page 198
– Checking the oil level ⇒ Maintenance ; Booklet Octavia II .
Note
To ensure the oil supply to the exhaust gas turbocharger, leave
the engine running for about 1 minute after installing the exhaust
gas turbocharger.
2.2 Removing and installing charge air cooling parts for engines with code BKD,
AZV
Note
Before testing or repairing, check all hoses and lines for tight connection and leaks.
♦
Hose connections and hoses for the charge air system must be free of oil and grease before being installed.
♦
Secure all hose connections with corresponding hose clips.
♦
2.0/100; 103 kW TDI PD Engine - Edition 01.2018
⇒ page 229 .
⇒ page 239
.
Octavia II 2004 ➤ , Octavia II 2010 ➤
.
2. Charge-air system with exhaust gas turbocharger - Part 2
191