Removing And Installing The Sealing Flange On The Belt Pulley Side - Skoda Octavia II 2004 Workshop Manual

– Press in the gasket ring flush with the central screw for the
toothed belt sprocket of the crankshaft and with the pressure
bushing of the assembly device - T10053- .
Note
There must not be any oil present on the contact surface be‐
♦
tween toothed belt sprocket and crankshaft.
Replace central screw for crankshaft toothed belt sprocket.
♦
Do not oil the central screw for crankshaft toothed belt sprock‐
♦
et.
– Remove the crankshaft toothed belt sprocket; to do so, hold
toothed belt sprocket with counterholder - T30004 - or lock with
counterholder - MP 1-310 (3099)- .
– Installing the timing belt.
♦ Motor code BKD, AZV:
♦ Engine code BMM:
2.2 Removing and installing the sealing
flange on the belt pulley side
Special tools and workshop equipment required
♦ Counterholder - T30004 - or counterholder for toothed belt
sprocket - MP 1-310 (3099)-
♦ Assembly tool - T10053-
♦ Sealant remover gasket stripper (bearing code GST, bearing
article no. R 34402), manufacturer Retech s.r.o.
♦ Protective goggles and gloves
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not permitted
unless authorised by ŠKODA AUTO A. S. ŠKODA AUTO A. S. does not guarantee or accept any liability
♦ Cleaning and degreasing agent , e.g. - D 000 401 04-
with respect to the correctness of information in this document. Copyright by ŠKODA AUTO A. S.�
♦ Silicone sealant - D 176 404 A2-
Removing
• Engine installed.
– Remove toothed belt.
♦ Motor code BKD, AZV:
♦ Engine code BMM:
⇒ page 26
⇒ page 38
⇒ page 26
⇒ page 38
Octavia II 2004 ➤ , Octavia II 2010 ➤
2.0/100; 103 kW TDI PD Engine - Edition 01.2018
2. Removing and installing sealing flange and flywheel
51