Skoda Octavia II 2004 Workshop Manual page 18

Octavia II 2004 ➤ , Octavia II 2010 ➤
2.0/100; 103 kW TDI PD Engine - Edition 01.2018
– Open the cable guides -arrows-, remove the engine wiring
harness and place down to the side.
– Release all remaining plugs at engine and gearbox and lay
aside the relevant lines.
Note
To release the plug of the engine speed sensor - G28- , push
down on the plug with a screwdriver while lifting the release button
with a thin wire hook.
– Detach all connecting and vacuum hoses from the engine as
well as the coolant hoses.
Vehicles fitted with a manual gearbox
– Remove shift mechanism from gearbox ⇒ gearbox ⇒ Rep.
gr. 34 .
– Remove pressure line from breather/slave cylinder ⇒ Gearbox
⇒ Rep. gr. 30 .
WARNING
After separating the hydraulic line, do not operate the clutch
pedal.
Vehicles with automatic gearbox
– Remove shift mechanism from gearbox ⇒ gearbox ⇒ Rep.
gr. 34 .
Continued for all vehicles
– Screw engine mount - T10012- to the cylinder block with nut
-2- and screw -1- to 20 Nm.
– Insert engine/gearbox jack - V.A.G 1383 A- in the engine
mount and slightly raise.
WARNING
Use double ladder to release the screws for the engine/gear‐
box mounting.
12
Rep. gr.10 - Removing and installing engine
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not permitted
unless authorised by ŠKODA AUTO A. S. ŠKODA AUTO A. S. does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by ŠKODA AUTO A. S.�