Skoda Octavia II 2004 Workshop Manual page 81

– Disconnect connector -2-, unscrew screw -4- and remove front
charge air hose together with connecting hose; do so by lifting
retaining clips -1- and -3-.
– Unbolt heat shield for right drive shaft -arrows-.
– Remove pre-exhaust pipe from exhaust gas turbocharger, re‐
lease clamping sleeve and push pre-exhaust pipe to the rear
⇒ page 229 ,
– Release screws -1- and -2- and remove the support for turbo‐
charger.
Note
Collect any engine oil which flows out with a cloth.
– Remove the oil return line -3- at the cylinder block.
– Unscrew oil feed line from turbocharger, exhaust manifold and
coolant pipe and lay it to one side.
– Remove connection pipe for exhaust gas recirculation be‐
tween mechanical valve and exhaust gas recirculation cooler
⇒ page 241 .
– Remove camshaft sprockets and remove hubs for camshafts
⇒ page 27 .
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not permitted
unless authorised by ŠKODA AUTO A. S. ŠKODA AUTO A. S. does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by ŠKODA AUTO A. S.�
Octavia II 2004 ➤ , Octavia II 2010 ➤
2.0/100; 103 kW TDI PD Engine - Edition 01.2018
1. Removing and installing cylinder head
75