Skoda Octavia II 2004 Workshop Manual page 95

– Unscrew the screws from the support of the intake manifold
flap motor - V157- -arrows-.
For vehicles with auxiliary heating:
– Remove coolant pipes to auxiliary heating with connected
coolant hoses at cylinder block.
Continued for all vehicles
– Remove camshaft sprocket and hub
– Remove timing belt tensioning pulley.
– Unscrew the rear toothed belt guard fixing screws -2- and
-4-.
– Unscrew screw -3- and remove Hall sender - G40- from cyl‐
inder head.
Vehicles as of 03.07
– Screw bracket - T10014- into the threaded hold above the
coolant pump. Tighten screw for bracket to 20 Nm.
– Carefully raise the engine with spindle -A-, thereby releasing
the spindle -B-.
– Push spindle -B- forwards.
Continued for all vehicles
– Remove cylinder head cover
2.0/100; 103 kW TDI PD Engine - Edition 01.2018
⇒ page 113 .
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not permitted
unless authorised by ŠKODA AUTO A. S. ŠKODA AUTO A. S. does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by ŠKODA AUTO A. S.�
⇒ page 83 .
Octavia II 2004 ➤ , Octavia II 2010 ➤
1. Removing and installing cylinder head
89