Skoda Octavia II 2004 Workshop Manual page 36

Octavia II 2004 ➤ , Octavia II 2010 ➤
2.0/100; 103 kW TDI PD Engine - Edition 01.2018
Engine support bracket
On vehicles manufactured from 05.05, the engine support -2- is
in-built.
Note
When removing the toothed belt, it is not necessary to remove the
engine support.
Tightening order for engine support
Caution
The tightening sequence and the tightening torque of the fixing
screws for the engine support must definitely be respected.
Otherwise stress of the engine support bracket occurs, which
results in the breaking of the engine support bracket.
1. Screw in screws -1...3- by hand first.
2. Then tighten the screws to 40 Nm in the sequence -1...3-.
3.
Then tighten the screws a further 180° (
quence -1 ... 3-.
Note
To do so, lift or lower the engine with the supporting device -
♦
T30099 - .
Before the engine mount is installed, all the screws of the en‐
♦
gine support must be tightened to the specified tightening
torque.
I: Engine support for vehicles until 05.05
II: Engine support for vehicles from 05.05
1.2.3 Removing toothed belt
Special tools and workshop equipment required
♦ Supporting device - T30099-
♦ Surface - T30099/1-
♦ Hook - MP 9-200/10 (10-222A/10)-
♦ Rig pin for the injection pump - 3359- or -MP 1-301 - (2x)
♦ Locking pin - T10060- or -T10060A -
♦ Crankshaft arrester - T10050- or - T10100-
30
Rep. gr.13 - Crankshaft group
1
/ 2 turn) in the se‐
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not permitted
unless authorised by ŠKODA AUTO A. S. ŠKODA AUTO A. S. does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by ŠKODA AUTO A. S.�