Octavia II 2004 ➤ , Octavia II 2010 ➤
2.0/100; 103 kW TDI PD Engine - Edition 01.2018
♦ Locking pin - T10060- or -T10060A -
♦ Catch pan for workshop cranes , e.g. -VAS 6208-
♦ Pliers for spring-type clips
♦ Sealant remover gasket stripper (bearing code GST, bearing
article no. R 34402), manufacturer Retech s.r.o.
♦ Protective goggles and gloves
1.3.1
Removing
– Switch off ignition and pull out ignition key.
– Remove engine cover
– Remove air filter with air guide hose and intake hose
⇒ page 208
.
– Drain coolant
⇒ page 135
– Safety instructions when working on the injection system
⇒ page 3
.
– Detach fuel feed line -3- and fuel return-flow line -2-, to do so
press in securing ring.
– Extract fuel from the fuel tank
– Remove toothed belt
For vehicles up to 05.05, support the engine as described be‐
low.
Vehicles up to 05.05
– Screw bracket - T10014 - into the threaded hold above the
coolant pump. Tighten screw for bracket to 20 Nm.
– Carefully raise the engine with spindle -A-, thereby releasing
the spindle -B-.
– Push spindle -B- forwards.
Continued for all vehicles
74
Rep. gr.15 - Cylinder head, valve gear
⇒ page 13
.
.
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not permitted
unless authorised by ŠKODA AUTO A. S. ŠKODA AUTO A. S. does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by ŠKODA AUTO A. S.�
⇒ page 171
.
⇒ page 26
.