Skoda Octavia II 2004 Workshop Manual page 120

Octavia II 2004 ➤ , Octavia II 2010 ➤
2.0/100; 103 kW TDI PD Engine - Edition 01.2018
– Oil the thread head of the gasket ring extractor, position and
forcibly screw into the gasket ring of the camshaft as far as
possible.
– Release knurled screw and turn the inner side against the
camshaft until the gasket ring is pulled out.
– Clamp gasket ring extractor into the vice and remove gasket
ring with pliers.
– Clean the contact and sealing surfaces.
Installing
Installation occurs in reverse order to removal. Pay attention to
the following:
Note
The sealing lip of the gasket ring must neither be oiled nor
greased additionally.
– Remove oil residue from the camshaft stud with a clean cloth.
– Cover slot on the camshaft cone with adhesive tape and care‐
fully push the sealing ring onto the camshaft.
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not permitted
unless authorised by ŠKODA AUTO A. S. ŠKODA AUTO A. S. does not guarantee or accept any liability
– Press in the sealing ring up to the stop using the thrust piece
with respect to the correctness of information in this document. Copyright by ŠKODA AUTO A. S.�
of the insertion tool - MP 1-214- and screw M12 x 65.
– Position hub onto camshaft.
– Tighten screw -1- to 100 Nm, use counterholder - T10051- to
hold.
114
Rep. gr.15 - Cylinder head, valve gear