Connect The Brake Lines From The Master Brake Cylinder To The Hydraulic Unit - Left-Hand Drive; Removing And Installing Abs Control Unit J104 Abs Hydraulic Unit N55 - Left -Hand Drive Vehicles - Skoda Octavia II 2004 Workshop Manual

5.2 Connect the brake lines from the master
brake cylinder to the hydraulic unit - left-
hand drive
Connect brake lines to the master brake cylinder
A - from master brake cylinder (push rod piston circuit) to ABS
hydraulic unit
- Distinguishing feature: pipe screw with thread M12 x 1
B - from master brake cylinder (floating piston circuit) to ABS hy‐
draulic unit
- Distinguishing feature: pipe screw with thread M12 x 1
1 - Hydraulic unit to front left brake caliper
3 - hydraulic unit to rear right brake caliper
4 - hydraulic unit to rear left brake caliper
Connect brake lines to the hydraulic unit.
A - from master brake cylinder (push rod piston circuit) to ABS
hydraulic unit
- Distinguishing feature for vehicles up to CW 21/2008: pipe screw
with thread M10 x 1
- Distinguishing feature for vehicles as of CW 22/2008: pipe screw
with thread M12 x 1
B - from master brake cylinder (floating piston circuit) to ABS hy‐
draulic unit
- Distinguishing feature: pipe screw with thread M12 x 1
1 - Hydraulic unit to front left brake caliper
- Distinguishing feature for vehicles up to CW 21/2008: pipe screw
with thread M12 x 1
- Distinguishing feature for vehicles as of CW 22/2008: pipe screw
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not permitted
with thread M10 x 1
unless authorised by ŠKODA AUTO A. S. ŠKODA AUTO A. S. does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by ŠKODA AUTO A. S.�
2 - Hydraulic unit to front right brake caliper
- Distinguishing feature for vehicles up to CW 21/2008: pipe screw
with thread M10 x 1
- Distinguishing feature for vehicles as of CW 22/2008: pipe screw
with thread M12 x 1
3 - hydraulic unit to rear right brake caliper
- Distinguishing feature: Pipe screw with thread M10 x 1
4 - hydraulic unit to rear left brake caliper
- Distinguishing feature: pipe screw with thread M12 x 1
5.3 Removing and installing ABS control
unit - J104- ABS hydraulic unit - N55- -
left -hand drive vehicles
Special tools and workshop equipment required
♦ Brake pedal load e.g. -V.A.G 1869/2-
Removing:
Fitting location:
5. Hydraulic Control Unit, Brake Servo Unit/Master Brake Cylinder ABS Mark 70 (ABS/TCS)
Octavia II 2004 ➤ , Octavia II 2010 ➤
Brake systems - Edition 11.2017
45