Intake Manifold - Summary Of Components For Engines With Code Bmm - Skoda Octavia II 2004 Workshop Manual

Summary of components - plug on the front wall
1 - Solenoid valve for charge pressure control - N75-
2 - Plug (orange) for exhaust gas temperature sender 3 - G495-
( temperature sender downstream particle filter - G527- )
3 - Plug for exhaust gas temperature sender 2 - G448- ( temper‐
ature sender upstream of particle filter - G506- )
4 - Plug for lambda probe - G39- with heating for lambda probe -
Z19-
5 - Plug for exhaust gas temperature sender 1 - G235- ( temper‐
ature sender upstream of turbocharger - G507- )
1.10

Intake manifold - summary of components for engines with code BMM

1 - Gasket
❑ replace
2 - Intake manifold
3 - Sealing ring
❑ replace
4 - Supports
5 - Intake manifold flap motor -
V157-
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not permitted
❑ The intake manifold flap
unless authorised by ŠKODA AUTO A. S. ŠKODA AUTO A. S. does not guarantee or accept any liability
is closed for about 3 with respect to the correctness of information in this document. Copyright by ŠKODA AUTO A. S.�
seconds after switching
off the engine and then
opens again. This re‐
duces the switch-off im‐
pact.
6 - from charge-air cooler
7 - 10 Nm
8 - Electric exhaust gas recir‐
culation valve - N18- with EGR
potentiometer - G212- and
EGR control motor - V338-
❑ before installing, check
sealing surfaces at in‐
take manifold for dirt
and clean as required
❑ After replacing, adapt
new part as follows:
– Switch ignition on and
off; then wait 1 minute
for the afterrun of the
control units.
– Start engine and run in
idle for at least 1 minute.
– Interrogate the fault memory ⇒ Vehicle diagnostic tester.
Octavia II 2004 ➤ , Octavia II 2010 ➤
2.0/100; 103 kW TDI PD Engine - Edition 01.2018
1. Repairing Diesel Direct Injection system
219