Skoda Octavia II 2004 Workshop Manual page 159

the fuel gauge sender -
G- ⇒ page 167
5 - Lock ring, 110 Nm
❑ use wrench - T30101 (3087)- for removing and installing
❑ check for firm seating
6 - Fuel tank lid unit
❑ with rubber bowl
❑ removing and installing ⇒ Body Work ⇒ Rep. gr. 55
7 - Screw cap
8 - Mounting part
9 - Earth connection
❑ check for firm seating
10 - 10 Nm
11 - Suction spray pump
❑ connected to the fuel gauge sender 2 - G169-
❑ Removing and installing
12 - Fuel gauge sender - G169-
❑ Note installation position on the fuel tank
❑ Removing and installing
13 - Fuel tank
❑ when removing, support using the engine/gearbox jack , e.g. -V.A.G 1383 A-
❑ Removing and installing
14 - Tensioning strap
❑ Check fitting position
15 - 25 Nm
❑ replace
16 - Heat shield
17 - Fuel cooler
❑ Removing and installing
18 - to fuel filter
19 - 20 Nm
Installation position of the fuel delivery unit (with fuel gauge send‐
er - G- ) and with fuel gauge sender 2 - G169-
The markings on the flanges must be aligned with markings on
the fuel tank -arrows-.
Note
The markings on the fuel tank are hardly visible.
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not permitted
unless authorised by ŠKODA AUTO A. S. ŠKODA AUTO A. S. does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by ŠKODA AUTO A. S.�
2.0/100; 103 kW TDI PD Engine - Edition 01.2018
⇒ page 170
⇒ page 153
⇒ page 169
⇒ page 159
⇒ page 157
Octavia II 2004 ➤ , Octavia II 2010 ➤
1. Removing and installing parts of the fuel supply system
153