Removing And Installing The Camshaft For Engines With Code Bmm - Skoda Octavia II 2004 Workshop Manual

– Push camshaft sprocket onto the hub.
• The tooth segment -arrow- of the toothed belt sprocket must
be at the top.
– Slightly screw in plug -1-.
– Lock hub with locking pin e. g. - 3359- .
– install (set the timing)
2.12 Removing and installing the camshaft
for engines with code BMM
Special tools and workshop equipment required
♦ Counterholder - T10051-
♦ Extractor - T10052-
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not permitted
♦ Silicone sealant - D 176 404 A2-
unless authorised by ŠKODA AUTO A. S. ŠKODA AUTO A. S. does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by ŠKODA AUTO A. S.�
♦ Sealant - D 454 300 A2-
Removing
• Cylinder head attached at engine.
– Remove toothed belt
– Remove tandem pump
Note
The hoses can remain connected to the tandem pump.
– Remove camshaft sprocket and remove hubs
– Remove cylinder head cover
– Mark the valve-lever shafts with waterproof felt-tip pen to avoid
mixing them up and to avoid having to perform a basic setting
of the unit injectors -arrows-.
– First release the two outer -1- and then the inner screws -2- of
the valve-lever shafts.
– Remove valve-lever shafts.
⇒ page 38 .
⇒ page 38 .
⇒ page 171 .
⇒ page 83 .
Octavia II 2004 ➤ , Octavia II 2010 ➤
2.0/100; 103 kW TDI PD Engine - Edition 01.2018
⇒ page 113 .
115
2. Repairing Valve Gear