Exhaust System For Vehicles With Four-Wheel Drive - Summary Of Components - Skoda Octavia II 2004 Workshop Manual

1.3 Exhaust system for vehicles with four-wheel drive - Summary of compo‐
nents
1 - Exhaust gas pressure sen‐
sor 1 - G450-
2 - Mounting bracket
❑ for pressure line
3 - Pressure line - 45 Nm
4 - 10 Nm
5 - Lambda probe - G39- ,
50 Nm
❑ the thread of new lamb‐
da probes must be coat‐
ed with assembly paste
❑ for re-used lambda
probe, only coat the
thread with hot bolt
paste - G 052 112 A3- ;
the hot bolt paste - G
052 112 A3- must not
get into the slots of the
probe body
6 - Exhaust gas temperature
sender 2 - G448- ( Tempera‐
ture sender upstream particle
filter - G506- )
❑ 45 Nm
❑ the thread of new tem‐
perature transmitters
must be coated with as‐
sembly paste
❑ Grease only the thread
with hot bolt paste - G
052 112 A3- for re-used
temperature sender.
7 - Pre-exhaust pipe with die‐
sel particle filter
❑ Removing and installing
8 - Exhaust gas temperature sender 3 - G495- ( Temperature sender downstream particle filter - G527- )
❑ 45 Nm
❑ the thread of new temperature transmitters must be coated with assembly paste
❑ Grease only the thread with hot bolt paste - G 052 112 A3- for re-used temperature sender.
9 - Identification
❑ for clamping sleeve
10 - Front clamping sleeve
❑ align exhaust system free of stress before fitting on
❑ Tighten screwed connections uniformly
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not permitted
unless authorised by ŠKODA AUTO A. S. ŠKODA AUTO A. S. does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by ŠKODA AUTO A. S.�
2.0/100; 103 kW TDI PD Engine - Edition 01.2018
⇒ page 234
Octavia II 2004 ➤ , Octavia II 2010 ➤
⇒ page 239
1. Removing and installing parts of the exhaust system
233