Skoda Octavia II 2004 Workshop Manual page 45

❑ install (set the timing)
8 - 20 Nm + torque a further 45° (
9 - Tensioning pulley
❑ The eccentric of the new version has an additional hole for 6 mm hexagon socket wrench
10 - 25 Nm
11 - Camshaft toothed belt pulley
❑ Mark installation position
12 - 100 Nm
❑ to release and tighten use counterholder - T10051 -
13 - Hub
❑ with sensor rotor for Hall sensor - G40-
❑ to release and tighten use counterholder - T10051 -
❑ to remove use extractor - T10052-
❑ Removing and installing
14 - 10 Nm
❑ insert using locking agent - D 000 600 A2-
15 - Rear toothed belt guard
❑ to remove, unscrew coolant pump
❑ When installing, carefully insert into the front sealing flange - pulley side
16 - Rubber bowl
❑ Replace if damaged.
17 - 25 Nm
18 - O-ring
❑ replace
19 - Coolant pump
❑ Removing and installing
20 - 13 Nm Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not permitted
unless authorised by ŠKODA AUTO A. S. ŠKODA AUTO A. S. does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by ŠKODA AUTO A. S.�
21 - Guide pulley
22 - Crankshaft toothed belt sprocket
❑ there must not be any oil present on the contact surface between the pulley and the crankshaft
❑ can be installed only in one position
23 - 120 Nm + torque a further 90° (
❑ replace
❑ do not oil
❑ to release and tighten use counterholder - T30004 - or counterholder - MP 1-310 (3099)-
24 - 20 Nm
❑ self-locking, replace
25 - 10 Nm
❑ insert using locking agent - D 000 600 A2-
2.0/100; 103 kW TDI PD Engine - Edition 01.2018
⇒ page 45
1
/ 8 turn)
⇒ page 113
⇒ page 147
1
/ 4 turn)
Octavia II 2004 ➤ , Octavia II 2010 ➤
1. Disassembling and assembling engine
⇒ page 40
39