Removing And Installing Cylinder Head For Engines With Code Bkd, Azv - Skoda Octavia II 2004 Workshop Manual

– Remove top toothed belt guard; to do so, release retaining
clips -arrows-.
– Remove screws -1- and -3-.
– Remove crankcase ventilation hose -2- from charge air pipe
to turbocharger and push charge air pipe to rear.
Note
The charge air pipe -Position 4- remains connected to the tur‐
♦
bocharger.
The illustration shows the view from behind with engine re‐
♦
moved.
– Undo the screws for the cylinder head cover in the sequence
-11...1-.
– Unscrew the screws and remove cylinder head cover with
seal.
Installing
Installation occurs in reverse order to removal. Pay attention to
the following:
Note
Replace the gasket and the screws for the cylinder head cover in
case of damage.
– Tighten the screws for the cylinder head cover in the sequence
-1...1- initially by hand and then to 10 Nm.
1.3 Removing and installing cylinder head
for engines with code BKD, AZV
Special tools and workshop equipment required
♦ Supporting device - T30099-
♦ Surface - T30099/1-
♦ Hook - MP 9-200/10 (10-222A/10)-
♦ Mounting bracket - T10014-
♦ Counterholder - T10051 -
♦ Extractor - T10052-
♦ Rig pin for the injection pump - 3359- or -MP 1-301 - (2x)
♦ Crankshaft arrester - T10050- or crankshaft arrester - T10100-
2.0/100; 103 kW TDI PD Engine - Edition 01.2018
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not permitted
unless authorised by ŠKODA AUTO A. S. ŠKODA AUTO A. S. does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by ŠKODA AUTO A. S.�
Octavia II 2004 ➤ , Octavia II 2010 ➤
1. Removing and installing cylinder head
73