Securing The Engine To The Assembly Stand - Skoda Octavia II 2004 Workshop Manual

Octavia II 2004 ➤ , Octavia II 2010 ➤
2.0/100; 103 kW TDI PD Engine - Edition 01.2018
Vehicles with engine code BMM
– Remove outer -1- and inner -2- engine cover by pulling evenly
upwards.
Installing
Note
On vehicles with engine code BKD, AZV, the oil dipstick must be
pulled out of the dipstick guide before installation and pushed
back into the oil dipstick guide after installation.
Caution
Before installing the engine cover, check the correct installa‐
tion position of the 4 fastening elements (ball sockets). Put
them back in the correct positions if necessary. Otherwise this
can lead to damage to the engine cover.
– If necessary, press the ball sockets into the correct positions.
– Place the engine cover onto the fixing points and press it into
the catches.
1.2 Securing the engine to the assembly
stand
Special tools and workshop equipment required
♦ Lifting device - MP 9-201 (2024A)-
♦ Engine mount - MP 1-202 (VW 540)-
♦ Hook - MP 1-202/10-
♦ Bushing - T30010 (VW 540/1B)-
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not permitted
unless authorised by ŠKODA AUTO A. S. ŠKODA AUTO A. S. does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by ŠKODA AUTO A. S.�
♦ Assembly stand - MP 9-101-
♦ Workshop crane , e.g. -VAS 6100-
Work procedure
• Separate engine from gearbox.
14
Rep. gr.10 - Removing and installing engine