Skoda Octavia II 2004 Workshop Manual page 23

– Successively screw in screws for gearbox mount -arrows- by
hand.
– Adjust assembly bracket
⇒ page 19 .
– Remove engine mount - T10012- from engine.
Vehicles with four-wheel drive
– Attach propshaft to gearbox ⇒ Gearbox ⇒ Rep. gr. 39 .
– Attach assembly carrier without steering gear ⇒ Chassis ⇒
Rep. gr. 40 .
Continued for all vehicles
– Screw on pendulum support with new screws -2- and -3- at
gearbox and then tighten with new screw -1- at assembly car‐
rier.
Tightening torque: ⇒ page 19
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not permitted
unless authorised by ŠKODA AUTO A. S. ŠKODA AUTO A. S. does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by ŠKODA AUTO A. S.�
2.0/100; 103 kW TDI PD Engine - Edition 01.2018
⇒ page 20 and tighten screws
Octavia II 2004 ➤ , Octavia II 2010 ➤
1. Removing and installing engine
17