Skoda Octavia II 2004 Workshop Manual page 201

– Disconnect plug connection -5- for exhaust gas temperature
sender 1 - G235- ( temperature sender upstream turbocharger
- G507- ) and expose cable.
– Remove pre-exhaust pipe with diesel particle filter
⇒ page 234 .
– Unplug connector on air mass meter - G70-
– Remove connecting pipe and intake hose
– Remove connecting piece for intake hose on exhaust gas tur‐
bocharger ⇒ page 193
– Remove vacuum line to vacuum actuator (Pos. 5).
– Remove oil supply hose (Pos. 4).
– Remove right drive shaft ⇒ Chassis ⇒ Rep. gr. 40 .
– Detach the connecting hose from the turbocharger
⇒ page 196 .
– Remove the connecting pipe for the exhaust gas recirculation
⇒ page 247 .
– Exhaust gas temperature sender 1 - G235- ( temperature
sender upstream from turbocharger - G507- ) -arrow- using a
wrench from set of tools SW 17 - T10395- .
Vehicles with auxiliary heating
– Unscrew screws for coolant pipes for auxiliary heating and
push off pipes to the left.
Vehicles with four-wheel drive
– Remove the right flange shaft of the angle gearbox ⇒ Gearbox
⇒ Rep. gr. 39 .
Continued for all vehicles
– Unscrew screw -2- and hollow screw -3-.
– Rotate the turbocharger support 90° and pull it down and out
of the oil return line.
⇒ page 216
⇒ page 220
.
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not permitted
unless authorised by ŠKODA AUTO A. S. ŠKODA AUTO A. S. does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by ŠKODA AUTO A. S.�
Octavia II 2004 ➤ , Octavia II 2010 ➤
2.0/100; 103 kW TDI PD Engine - Edition 01.2018
.
.
2. Charge-air system with exhaust gas turbocharger - Part 2
195