– Unplug connector of the glow plugs -arrows-.
– Remove the glow plugs using a flexible-head wrench e.g.
-3220- .
Installing
Installation occurs in reverse order to removal. Pay attention to
the following:
– Install glow plugs and tighten to 15 Nm.
1.4
Checking the glow plugs for engines
with code BMM
Special tools and workshop equipment required
♦ Handheld multimeter - V.A.G 1526 B-
Test conditions
•
Ignition off.
Test sequence
– Unplug connector of the glow plugs.
– Connect handheld multimeter - V.A.G 1526 B- for resistance
measurement between contact and glow plug housing.
•
Specified resistance value: less than 1Ω
If the resistance value is exceeded (greater than 1 Ω), then the
glow plug is defective.
– Replace defective glow plug
– Check glow plugs in all cylinders one after the other.
– Reconnect removed connectors for glow plugs.
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not permitted
unless authorised by ŠKODA AUTO A. S. ŠKODA AUTO A. S. does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by ŠKODA AUTO A. S.�
2.0/100; 103 kW TDI PD Engine - Edition 01.2018
⇒ page 250
.
Octavia II 2004 ➤ , Octavia II 2010 ➤
1. Glow Plug System
251