Skoda Octavia II 2004 Workshop Manual page 88

Octavia II 2004 ➤ , Octavia II 2010 ➤
2.0/100; 103 kW TDI PD Engine - Edition 01.2018
1 - Vacuum hose
❑ for connecting piece of
tandem pump / brake
booster
2 - Screw cap
3 - Connecting pipe
❑ for crankcase ventila‐
tion
❑ To intake hose
4 - Screw with spacer sleeve,
10 Nm
❑ Pay attention to se‐
quence for loosening
and tightening
⇒ page 83
5 - Tandem pump
❑ Removing and installing
⇒ page 172
❑ Check ⇒ page 174
6 - 20 Nm
7 - 10 Nm
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not permitted
unless authorised by ŠKODA AUTO A. S. ŠKODA AUTO A. S. does not guarantee or accept any liability
8 - Coolant flange
with respect to the correctness of information in this document. Copyright by ŠKODA AUTO A. S.�
9 - O-ring
❑ replace
10 - 10 Nm
11 - Sealing rings
❑ replace
12 - Mixing tube
❑ inserted in the head
❑ pull out with hook
13 - Cylinder head gasket
❑ Replace ⇒ page 90
❑ Pay attention to the marking
14 - Hall sender - G40-
❑ for camshaft position
15 - 10 Nm
❑ install with locking agent - D 000 600 A2-
16 - 15 Nm
17 - 100 Nm
❑ to release and tighten use counterholder - T10051 -
18 - Hub
❑ with sensor rotor for Hall sensor - G40-
❑ to remove use extractor - T10052-
❑ remove ⇒ page 113
19 - Cylinder head
❑ Removing ⇒ page 85
❑ check for distortion
❑ installing ⇒ page 90
82
Rep. gr.15 - Cylinder head, valve gear
⇒ page 72
⇒ page 83