Skoda Octavia II 2004 Workshop Manual page 228

Octavia II 2004 ➤ , Octavia II 2010 ➤
2.0/100; 103 kW TDI PD Engine - Edition 01.2018
1.13.1 Removing
– Remove top toothed belt guard and cylinder head cover
⇒ page 83 .
– Undo the locknuts -2- of the adjusting screws for all unit injec‐
tors and unscrew adjusting screws until the respective valve
lever is resting on the spring plate of the unit injector.
– Screw out fixing screws -2- for the valve-lever shaft from the
outside to the inside and remove the valve-lever shaft.
– Adjust the camshaft so that the cam for cylinder 2 -arrow- is in
the position shown. All clamping pads can be removed in this
position.
– Unplug the connector from the unit injector. Support the op‐
posite side of the connector with your finger in order to avoid
twisting the connector.
– Unscrew fixing screw -3- of the clamping pad (illustration
above) and remove the pad towards the camshaft.
– Insert extractor - T10055- in direction of the camshaft instead
of the clamping pad in the slot of the unit injector.
– Remove the unit injector by knocking on the sleeve on the nut
in the -direction of the arrow-.
Note
Do not interchange the unit injectors, if necessary mark the as‐
signment to each cylinder.
222
Rep. gr.23 - Mixture preparation - injection
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not permitted
unless authorised by ŠKODA AUTO A. S. ŠKODA AUTO A. S. does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by ŠKODA AUTO A. S.�