Skoda Octavia II 2004 Workshop Manual page 85

– Before inserting the valve-lever shaft, check that all ball studs
-1- and O-rings -2- have been inserted in the unit injectors.
– Screw in the valve-lever shaft and bearing bush as follows:
– Replace screws -1 ... 5-.
Se‐
quence
I – Alternately tighten screws -2- and -4- in stages
until the valve-lever shaft is resting on the bearing
bush.
II – Tighten screws -1-, -3- and -5- to 20 Nm + torque
a further 90° (
III – Tighten screws -2- and -4- to 20 Nm + torque a
further 90° (
IV – Tighten bearing frame screws -6...10- to 20 Nm.
– Insert screws -2...5- with applied locking agent - D 000 600
A2- and tighten to 10 Nm.
– Screw in the pin screw -1- and tighten to 10 Nm.
– Place hub on exhaust camshaft.
– Tighten screw -1- to 100 Nm, use counterholder - T10051- to
hold.
– In the same way, place hub on intake camshaft and tighten the
hub.
Apply
1
/ 4 turn).
1
/ 4 turn).
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not permitted
unless authorised by ŠKODA AUTO A. S. ŠKODA AUTO A. S. does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by ŠKODA AUTO A. S.�
Octavia II 2004 ➤ , Octavia II 2010 ➤
2.0/100; 103 kW TDI PD Engine - Edition 01.2018
1. Removing and installing cylinder head
79