Checking And Adjusting The Assembly Bracket - Skoda Octavia II 2004 Workshop Manual

Octavia II 2004 ➤ , Octavia II 2010 ➤
2.0/100; 103 kW TDI PD Engine - Edition 01.2018
1)
On manual gearbox MQ350 (02Q), only use the screws with the
strength category 10.9 if threaded inserts (e.g. Heli Coil) -arrow-
have been installed.
1.5 Checking and adjusting the assembly
bracket
1.5.1 Checking the assembly bracket
Check dimensions on the right hanger for engine/gearbox unit:
• Between engine bracket and engine support there must be a
distance -a- of 10 ... 13 mm.
• The cast iron edge on the engine support -2- must be parallel
to the supporting arm -1- the dimension -x- must be the same
at the front and rear.
Note
The distance -a- can be checked, for example with suitable round
bars.
Only if there is an acoustic complaint (engine or gearbox knock
on the frame side rail when cornering) and the dimension -a- is
outside 10 ... 13 mm:
– Adjust the assembly bracket
1.5.2 Adjusting the unit mounting
Special tools and workshop equipment required
♦ Supporting device - T30099-
♦ Surface - T30099/1-
♦ Hook - MP 9-200/10 (10-222A/10)-
– Remove battery and battery tray ⇒ Electrical System ⇒ Rep.
gr. 27 .
– Remove the cooling water tank cover ⇒ Body Work ⇒ Rep.
gr. 66 .
20
Rep. gr.10 - Removing and installing engine
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not permitted
unless authorised by ŠKODA AUTO A. S. ŠKODA AUTO A. S. does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by ŠKODA AUTO A. S.�
⇒ page 20 .