Skoda Octavia II 2004 Workshop Manual page 50

Octavia II 2004 ➤ , Octavia II 2010 ➤
2.0/100; 103 kW TDI PD Engine - Edition 01.2018
Note
Markings on the toothed belt sprocket and on the crankshaft
♦
arrester must be in line with each other -arrow-.
The pin on the crankshaft arrester -arrow- must engage into
♦
the hole in the sealing flange.
The crankshaft arrester can only be fitted onto the toothed belt
♦
sprocket from the front side of the serration.
– Mark the direction of rotation of the toothed belt with chalk or
a felt-tip pen.
– Loosen screws -arrows- for toothed belt sprocket by approx.
1 turn.
– Loosen the fixing nut -1- of the tensioning pulley.
– Turn the eccentric of the tensioning pulley with the offset
screwdriver - T10264- in anti-clockwise direction -arrow- until
the tensioning pulley can be interlocked with the rig tool -
T10265 - .
– Now turn eccentric of the tensioning pulley clockwise -arrow-
as far as the stop and tighten fixing nut -1- by hand.
– Firstly remove toothed belt from coolant pump toothed belt
sprocket and then from the other toothed belt sprockets.
44
Rep. gr.13 - Crankshaft group
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not permitted
unless authorised by ŠKODA AUTO A. S. ŠKODA AUTO A. S. does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by ŠKODA AUTO A. S.�