Skoda Octavia II 2004 Workshop Manual page 234

Octavia II 2004 ➤ , Octavia II 2010 ➤
2.0/100; 103 kW TDI PD Engine - Edition 01.2018
– Lift locking tab of protective cover with a cross-head screw‐
driver.
– Push the protective cover in the -direction of the arrow- out of
the bracket for engine control unit.
Continued for all vehicles
– Disconnect front plug -1- and remove from engine control unit.
– Lever off retaining bracket -2- slightly.
– Push engine control unit out of the bracket -arrow-.
– Disconnect rear plug and remove from engine control unit.
Installing
Note
For vehicles with protective cover, the metal swarfs must be suc‐
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not permitted
unless authorised by ŠKODA AUTO A. S. ŠKODA AUTO A. S. does not guarantee or accept any liability
tioned out of the plenum chamber before installing the engine
with respect to the correctness of information in this document. Copyright by ŠKODA AUTO A. S.�
control unit.
– Connect rear plug to engine control unit and lock.
– Push engine control unit into the bracket and lock the retaining
bracket -2-.
– Connect front plug to engine control unit and lock.
For vehicles with protective housing
– Fasten protective cover with new pull-off screws (before tight‐
ening align the protective cover in such a way that it does not
come into contact with the surrounding components)
Continued for all vehicles
– Install windscreen wiper and washer system ⇒ Electrical Sys‐
tem ⇒ Rep. gr. 92 .
– Install bulkhead plenum chamber and plenum chamber cover
⇒ Body Work ⇒ Rep. gr. 66 .
228
Rep. gr.23 - Mixture preparation - injection