Summary Of Components For Engines With Code Bmm - Skoda Octavia II 2004 Workshop Manual

1.2

Summary of components for engines with code BMM

1 - Exhaust gas pressure sen‐
sor 1 - G450-
2 - Mounting bracket
❑ for pressure line
3 - Pressure line - 45 Nm
4 - 10 Nm
5 - lambda probe - G39- - 50
Nm
❑ the thread of new lamb‐
da probes must be coat‐
ed with assembly paste
❑ for re-used lambda
probe, only coat the
thread with hot bolt
paste - G 052 112 A3- ;
the hot bolt paste - G
052 112 A3- must not
get into the slots of the
probe body
6 - Exhaust gas temperature
sender 2 - G448- ( Tempera‐
ture sender upstream particle
filter - G506- )
❑ 45 Nm
❑ the thread of new tem‐
perature transmitters
must be coated with as‐
sembly paste
❑ Grease only the thread
with hot bolt paste - G
052 112 A3- for re-used
temperature sender.
7 - Pre-exhaust pipe with die‐
sel particle filter
❑ Removing and installing
8 - Exhaust gas temperature sender 3 - G495- ( Temperature sender downstream particle filter - G527- )
❑ 45 Nm
❑ the thread of new temperature transmitters must be coated with assembly paste
❑ Grease only the thread with hot bolt paste - G 052 112 A3- for re-used temperature sender.
9 - Identification
❑ for front clamping sleeve
10 - to middle part of exhaust system
11 - 23 Nm
12 - Shackle
13 - Front tunnel bridge
14 - 20 Nm
15 - Shackle
16 - Rear part of exhaust system
❑ for first equipment building unit with middle part of exhaust gas system, replace individually when carrying
out repairs
⇒ page 234
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not permitted
unless authorised by ŠKODA AUTO A. S. ŠKODA AUTO A. S. does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by ŠKODA AUTO A. S.�
Octavia II 2004 ➤ , Octavia II 2010 ➤
2.0/100; 103 kW TDI PD Engine - Edition 01.2018
1. Removing and installing parts of the exhaust system
231