Skoda Octavia II 2004 Workshop Manual page 102

Octavia II 2004 ➤ , Octavia II 2010 ➤
2.0/100; 103 kW TDI PD Engine - Edition 01.2018
11 - Valve guide
❑ not to be replaced
❑ Check ⇒ page 121
12 - Valve lever for inlet valve
❑ do not mix up used valve levers (mark)
❑ with hydraulic valve clearance compensation
❑ Check roller bearings for easy running and play
❑ Removing and installing
13 - Valve lever for outlet valve
❑ do not mix up used valve levers (mark)
❑ with hydraulic valve clearance compensation
❑ Check roller bearings for easy running and play
❑ Removing and installing
14 - Sealing rings
❑ Do not oil or grease the sealing lip
❑ Remove oil from camshaft pin before installation
❑ Before installation, cover up the groove for spring on camshaft cone with suitable adhesive tape
❑ Removing and installing
15 - Cylinder head
❑ Valve seats must not be reworked.
16 - Inlet valves
❑ Valve dimensions
17 - Outlet valves
❑ Valve dimensions
18 - O-ring
❑ replace
19 - Valve lever pin for outlet valves
❑ Outlet side
❑ Removing and installing
20 - 10 Nm
21 - Screw plug - 10 Nm
❑ replace
22 - Valve lever pin for inlet valves
❑ Inlet side
❑ Removing and installing
23 - Bearing shell
❑ do not mix up used bearing shells (mark)
❑ ensure the retaining lugs are correctly located in the bearing caps and in the cylinder head
24 - Exhaust camshaft
❑ Inspecting axial play
❑ Removing and installing
25 - Inlet camshaft
❑ Inspecting axial play
❑ Removing and installing
26 - Bearing frame
❑ Pay attention to sequence for loosening and tightening
96
Rep. gr.15 - Cylinder head, valve gear
⇒ page 105
⇒ page 105
⇒ page 97
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not permitted
unless authorised by ŠKODA AUTO A. S. ŠKODA AUTO A. S. does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by ŠKODA AUTO A. S.�
⇒ page 110
⇒ page 110
⇒ page 105
⇒ page 105
⇒ page 97
⇒ page 98
⇒ page 97
⇒ page 98
⇒ page 98