Skoda Octavia II 2004 Workshop Manual page 123

– Oil contact surfaces of camshaft.
– Insert camshaft into the TDC for cylinder 1:
• The cams for cylinder 1 on the camshaft must point upwards
-arrows-.
– Then tighten bearing caps -2- and -4- alternately and cross‐
wise.
– On the outer bearing caps, apply a thin and even layer of seal‐
ant - D 454 300 A2- to the surfaces -1-.
Note
Make sure that sealant does not get into the grooves -arrows- or
onto the other surfaces.
– Install and tighten bearing caps -1-, -3- and -5-.
• Bearing cap -5- must fit flush with the outer edge of the cylinder
head as this may otherwise cause leaks on the tandem pump.
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not permitted
unless authorised by ŠKODA AUTO A. S. ŠKODA AUTO A. S. does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by ŠKODA AUTO A. S.�
Octavia II 2004 ➤ , Octavia II 2010 ➤
2.0/100; 103 kW TDI PD Engine - Edition 01.2018
117
2. Repairing Valve Gear