Skoda Octavia II 2004 Workshop Manual page 241

– Release fuel hoses and coolant hoses at right charge air pipe.
– Remove right charge air pipe.
– Check intake manifold flap motor - V157-
– Disconnect plug -1- and remove electric exhaust gas recircu‐
lation valve - N18- -arrows-
– Disconnect the following plug connections and move clear the
cables.
♦ Position 2: exhaust gas temperature sender 3 - G495- ( tem‐
perature sender downstream from particle filter - G527- )
♦ Position 3: exhaust gas temperature sender 2 - G448- ( tem‐
perature sender upstream from particle filter - G506- )
♦ Position 4: lambda probe - G39-
– Remove right front wheel.
– Remove noise insulation ⇒ Body Work ⇒ Rep. gr. 50 .
– Remove bottom part of right wheelhouse liner ⇒ Body Work
⇒ Rep. gr. 66 .
– Disconnect plug at oil level and oil temperature sender - G266-
⇒ page 122 .
– Remove drive shaft screening from the engine (if present).
– Unscrew the right drive shaft from the gearbox flange.
– Remove front tunnel bridge.
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not permitted
Vehicles with auxiliary heating
unless authorised by ŠKODA AUTO A. S. ŠKODA AUTO A. S. does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by ŠKODA AUTO A. S.�
– Unscrew screws for coolant pipes for auxiliary heating and
push off pipes to the left.
Vehicles with front-wheel drive
2.0/100; 103 kW TDI PD Engine - Edition 01.2018
⇒ page 246
⇒ page 246 .
Octavia II 2004 ➤ , Octavia II 2010 ➤
.
1. Removing and installing parts of the exhaust system
235