Skoda Octavia II 2004 Workshop Manual page 166

Octavia II 2004 ➤ , Octavia II 2010 ➤
2.0/100; 103 kW TDI PD Engine - Edition 01.2018
– Drain the fuel tank ⇒ page 155
– Removing rear seat bench ⇒ Body Work ⇒ Rep. gr. 72 .
– Remove the covers from the fuel delivery unit and from the fuel
gauge sender 2 - G169- .
Note
On vehicles with auxiliary heating, the plug connection for the
dosing pump - V54- must also be disconnected.
– Remove the plug from the fuel delivery unit and from the fuel
gauge sender 2 - G169- -arrows-.
– Remove right rear wheel ⇒ Chassis ⇒ Rep. gr. 44 .
– Open the fuel tank cap and clean around the fuel filler neck.
– Unscrew the cap from the fuel filler neck.
– Seal the opening with a clean piece of foam to prevent the
ingress of foreign bodies.
– Remove the rear right wheelhouse liner ⇒ Body Work ⇒ Rep.
gr. 66 .
– Remove screws -1- for filler neck on the body.
– Unclip the wiring loom from the holder -2- at the top and bottom
of the filler neck.
– Remove middle and rear part of exhaust system
⇒ page 233 .
– Remove propshaft ⇒ Gearbox ⇒ Rep. gr. 39 .
– Disconnect plug from four-wheel drive control unit - J492-
-arrow-.
– Disconnect the feed line and the return-flow line on the front
right of the fuel tank.
Note
On vehicles with auxiliary heating, the fuel line for the dosing
♦
pump - V54- must also be disconnected.
Press down the securing rings in order to unlock the connec‐
♦
tions of the fuel lines.
– Unscrew the straps.
– Support the fuel tank using the engine/gearbox jack - V.A.G
1383 A- .
– Unscrew securing bolts.
– Lower the fuel tank.
Installing
160
Rep. gr.20 - Fuel supply system
.
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not permitted
unless authorised by ŠKODA AUTO A. S. ŠKODA AUTO A. S. does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by ŠKODA AUTO A. S.�